open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi, dear sir

I have a problem with the bathymetry data.

1. I created e geometry file using BlueKenue and mapping the bathymetry data to the mesh.
2. From the Fudda Supervisor, I created a Telemac 2D project using the Geometry file that I created from Bluekenue.
3. I set all the parameters and boundary conditions for the model.
4. The model run with a message "correct end of run"
5. I open the result file with Fudda postprocessor

The problem is: the all bathymetry data is 0 at all time step.It seems that the bathymetry data were not read from the geometry file. ( My bathymetry data should be varied from 216.5m to 218.7m).

Could you plaese help me find out what happened during the creation of my project? Which step is not correct?

Thank you very much. I really appreciate your help.

Hello yyi,

try the following steps:
1. the name of your mesh file should be "BOTTOM"
2. move the mesh file to a new selafin object.
3. map the mesh with your bathymetry data.
4. check if all nodes have bathymetry data
5. save the selafin file
5. create project in Fudaa

It is important, that you map the mesh file AFTER you moved it to the selafin object.

I hope it helps!
Clemens