Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
PRE/POST PROCESSORS
Fudaa
Compute flow and problem saving workspace in new version 120
Flat Threaded

TOPIC: Compute flow and problem saving workspace in new version 120

Compute flow and problem saving workspace in new version 120 11 years 10 months ago #7039

  • pilou1253
  • pilou1253's Avatar
  • OFFLINE
  • openTELEMAC Guru
  • Posts: 584
  • Thank you received: 106
Hi Martin,

That would be just great! I also once asked if there will be a tool for extracting and mapping cross sectional results from telemac 3D. You said at that time that you were little short on time... How does this look today?

Thanks,
PL
The administrator has disabled public write access.

Compute flow and problem saving workspace in new version 120 11 years 10 months ago #7042

  • Serrer
  • Serrer's Avatar
  • OFFLINE
  • Moderator
  • Posts: 720
  • Thank you received: 304
Hi PL,

This is still "on the list"

Martin
The administrator has disabled public write access.
The following user(s) said Thank You: pilou1253

Compute flow and problem saving workspace in new version 120 11 years 10 months ago #7040

  • rouge
  • rouge's Avatar
Hi PL,

I repeated the same thing. Indeed, the curve of the hydrograph for a non-perpendicular profile is not correct. I forward this problem to the developer. I warn you when this is correct in the new version.

Best regards

Didier
The administrator has disabled public write access.

Compute flow and problem saving workspace in new version 120 11 years 10 months ago #7041

  • pilou1253
  • pilou1253's Avatar
  • OFFLINE
  • openTELEMAC Guru
  • Posts: 584
  • Thank you received: 106
Hi,

OK, thanks a lot.

Regards
PL
The administrator has disabled public write access.
Flat Threaded
Forum
PRE/POST PROCESSORS
Fudaa
Compute flow and problem saving workspace in new version 120

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.