open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi All,
I am new to Fudaaprepro, and a little bit confused here. I opened up the folder in the Supervisor, clicked on the geo file, then launched the post application by clicking on its tab which appeared with the geo file in the side window.
So got there, it showed me a 2D view of the bathymetry, so far so good. Clicked on export in the file menu but it doesn't allow me to export to a tablular format e.g. excel or csv?
Any tricks?
Thanks
Zeinab

A quick trick:

You can use Blue Kenue (www.nrc-cnrc.gc.ca/eng/ibp/chc/software/kenue/blue-kenue.html) from our Canadian colleagues to load the geo file (selafin file) and Save As ... xyz.

Hope this helps.

Sébastien.

sebourban wrote:
Hi, I am using Blue Kenue to Build a geo file for Telemac 2d. I hava already bulid a mesh model from ESRI grid, but I met a problem about how to export a geo file for TELEMAC. which file format should I export ? thanks for reply.

Please refer to the manual section entitled "Creating a SELAFIN File" in Chapter 2

Cheers... Martin

Hi Sébastien,
Thank you very much for pointing me into that direction. HAve never used Blue Kenue but found it very easy and quick to use. A very good feature in it is that it enables you to extract the boundary line.
In Fudaa prepro, I found that i need to click on the bathymetric image to activate the menu bar above, then when i click on the table symbol it offers me to export as a table. Also handy but haven't figured out how to separately extract boundary lines.
Thank you very much again.
Zeinab